Create & Bloom Crafts
Scalloped Heart Trinket Dish Silicone Mould for Epoxy Resin Crafts
Scalloped Heart Trinket Dish Silicone Mould for Epoxy Resin Crafts
Low stock: 5 left
Couldn't load pickup availability
Scalloped Heart Trinket Dish Silicone Mould for Epoxy Resin
Create delicate, decorative resin trinket dishes with this scalloped heart-shaped silicone mould. Its softly ruffled, wavy edge gives handmade epoxy resin pieces a romantic finish, ideal for jewellery holders, small keepsake dishes and decorative resin art.
Perfect for resin crafting
- Flexible silicone mould for casting epoxy resin craft projects
- Heart-shaped dish design with decorative scalloped, ruffled edges
- Great for handmade resin jewellery trays, ring dishes, trinket bowls and small decorative gifts
- Experiment with opaque resin pigments, mica powders, glitter, dried flowers and pearlescent effects
- Reusable mould; gently demould only once the resin has fully cured
Approximate mould dimensions
12.1cm wide × 11.9cm high × 2cm deep. Dimensions refer to the mould shown by the supplier; finished casting dimensions may vary slightly.
Resin craft inspiration
Pour a soft blush or ivory resin base for a French-inspired trinket dish, add a little shimmering mica for a pearl finish, or create striking contrast with bold pigments and gold accents. A lovely mould for resin makers creating handmade home décor and personalised gifts.
Helpful tips
Use a suitable casting epoxy resin and follow its recommended mixing ratio, maximum pour depth and cure time. Support the flexible mould on a flat, level surface during pouring and curing. This is a craft mould, not a food-use product.
What's included: 1 silicone mould. Resin, pigments and finished cast pieces are not included.
Important Information
Important Information
Top Tips for caring for your resin mould:
Ensure your workspace is clean, well-ventilated, and free of dust. This helps prevent unwanted particles from settling into the mould and resulting in lasting damage.
Always use a high-quality resin, suitable for your project such as Apex resin. Follow the manufacturer's recommendations for mixing ratios and curing times to ensure mould life is prolonged.
Gently pour the resin into the mould, starting from one corner to minimize the formation of air bubbles. Tap the mould lightly to release any trapped air.
Always demould your creations carfully to ensure you don't tear your mould
Do not use a eflame to pop bubbles, you may burn the mould or cause the resin to exotherm and stick to your mould
Clean your silicone mould with mild soap and water after each use. Avoid using harsh chemicals or abrasive materials, as this will damage your mould.
Store your moulds in an airtight container and ensure you keep them nice and flat.
Share
